![]() In sum, it’s kind of dangerous, no matter with which tool. Put ecu in boot mode if you wanna read write Note: MPPS V18 O.S: Windows 7 OK, but WIN XP, WIN 8, WIN 10 needs luck. So, 100 working on MPPS hardware v21 & hardware v18. But personally, I do not recommend you to write with Kess clone, Ktag smoothly)Įven if you would read-it, then you can’t write-it. Firmware version: 1.08.21, Software version: V18.12.3.8. (kess v2 or ktag don’t need resistor for this ecu. and MPPS V18 software adds boot mode support for controllers with the tricore processor and adds support for advanced functions on Marelli ECU’s.Here are the supported list and info below, Boot and TC mode are. You need to take the ECU apart and connect resistors etc to the circuit board MPPS V18 clone a powerful ecu programming tool for a range of controllers including M3.8, M5.9, ME7xx, MED9, MED17, EDC15/16/17, Delphi, Siemens, Marelli, Delco, Sagem, Trionic, etc. How to use MPPS V18 to read/write EDC17C46 through BOOT: i have gone to write another file to it but now the car will not ID or read/write. In have read it and write to it no problem. With MPPS v18, read and write 17c46 in boot mode. Hello everyone, i have a issue with a audi A3 1.9 tdi, the ecu is edc16u34. With Mpps, 100%īut i recommend you’d better have it via BOOT mode. Have not yet tried to write the OBD-Mpps file with Kess via OBD. The same option should also be possible with KTAG. You can make with Mpps the bootfile OBD-enabled and then write OBD. With kess v5.017 eu version, I read the file via bootmode tricore and wanted to upload the same original file by obd and get the message: file corrupted or not correct ![]() With kess v2 v4.036 firmware with update board work 100% on this ecu. But if you fail and have made full bootmode readout before you can recover ecu… Checksum correction from alientech is sometimes a little bit poor if you change something outside map area. ![]() Kess will automatically do tprot patch in this procedure. You can write boot readout or frf->bin file with kess obd, but you need to choose correct protocol. What’s the difference of EDC17C46 OBD reading by MPPS V18 & Kess V2 master? Look here: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |